ASLONG 54 Inch LED Light Bar 312W Combo Curved Off-Road Light with 2Pcs 4 Inch White/Amber LED Pods, Wiring Harness & Rocker Switch - Waterproof Fog Lights for Trucks, Jeeps, ATVs & Off-Road Adventures

This LED light bar puts out a ton of light. I'm over all happy with how it turned out. If your going to do this by yourself then it'll take you 1.5-2 hours.Easy to install and very brightCame with no instructions and parts do not mount anyplace but is supposed to be for my 2009 Jeep Wrangler.I have it installe my truck and it nice big lightOnce installed the main light bar looks good. I installed this on a 2004 GMC Yukon.I used the angled door brackets. These are not mentioned or shown at all. I needed to determine the orientation & where to mount. I drilled & then used flat headed screws to mount instead of the larger bolts that were included. The press fit holders were not very good & does not have proper teeth to hold.There are 2 different sizes or lengths of bolts too mount the light bar to the brackets. You need to use the short ones & may need to use several washers on the outside as even the short bolts can be a tad too long.I was able to route the power cable along the weather stripping into the engine bay. It does take some playing to determine the best placement for the wiring, where to mount the relays. I am using an available power tap in the under the hood fuse box.To route the controller cables you need to disconnect from the switch (take pics so you know how to re-connect the wires) to route the cable through the firewall and then to where you eventually want to mount the switch. The included wire harness has 1 set of wires that connects to the light bar and 2 sets for the smaller lights. Depending on your placement & routing you may need to add additional wiring. As these are LED's the power drain is not too massive.Once everything is connected the power switch has 3 positions, off, light bar only & Light bar with additional lights. The light switch does have a blue light to show when on in either position (only 1 light). A cut out template for the switch would have been nice so I did not need to eye ball it & slowly make larger to just fit.The smaller additional lights have several modes:Amber OnlyWhite Light OnlyAmber & White lightsFlashing Amber onlyFlashing White OnlyFlashing Amber / white (fast flash between both modes).You turn these on & off & back on to cycle though the modes. These are not selectable via the switch other then turning off & on until they are where you want them.Don't hit the light bar too hard at the car wash as it does not seem to be sealed as good as it should. I noticed moisture after giving my Yukon a wash this afternoon.The main light bar does provide a good amount of light. I will later hook up the smaller lights facing the rear as I already have several additional facing forward on a grill guard bar.Brackets are kind of flimsy. Comes with everything for install except the wiring.This light bar is easy to install and very sturdy and durable. This is amazing! It works perfectly as advertised! Great value for money. I highly recommend!I installed this on a dump truck for more job site light and boy did it work. Installation was easy and the different modes are nice. I used the pods for side light and so far after 2 months of use they are holding up well. I would highly recommend!